Opening Guide

[Aunt Haruka]

H2H Room

Start with Lighting and Ventilation if necessary . 

Turn the following switch 2-3 clicks until both blubs illuminate , 

   

Plug in the following lighting plugs into the outlets as shown . The Christmas lights plug in parallel on the top outlet, and the longer power block lighting in the bottom outlet . 

   

If ventilation is required , there is a fan here :

   

There is passive and active ventilation . In warmer weather if HVAC is not running , the window behind the fan can be opened . Otherwise , the fan can be operated during normal HVAC running hours by plugging in as the following out configuration . The fan will automatically power when plugged in .

   

Each Versatile City ( Head to Head Setup ) is powered by a single independent power strip . Flip each power switch and you will see a glowing orange indicator light .

Station A

   

Station B

   

Press the Power Button on Station A here :

   

Press the Power Button on Station B here :

   

The spectator monitors automatically power on . The CRTs will possibly power on automatically depending on the state they were in when the Main Power Strips were flipped off . You will briefly see NTSC Color Bars to indicate that the machines are booting . This may only show on the spectator monitors . 

   

The fans tilt and rotate per any direction the player may wish to use , they can also be positioned up and down .  The fans are controlled via a power button on the rear located on the rear .

   
   

Setup A player monitors MUST only be powered by use of the following remote :

   

It is tagged on the rear and face , and controls both sides . ONLY use the Power Button . Volume is handled independently and pre-set . Audio is not handled by the displays . These front buttons have faulty tact switches . The only thing not serviced on these chassis . 

   

The Verastile City B ( on the right hand side - closer to the door ) remote is pictured below . You may use BOTH the power button AND volume controls . 

   

To boot 3rd Strike , move to the taskbar with the mouse , select steam and move to the top and select 30th Anniversary Collection on both machines .

   

There is one mouse for both machines . It is plugged in normally on the Versatile City A Setup . ONLY plug in a keyboard or mouse into the following front ports . USB is specifically configured on the ports where players plug in controllers . Plugging a keyboard or mouse here will identify as a controller .