03-06-2024, 03:01 PM
(This post was last modified: 03-06-2024, 03:02 PM by Um Jamma Yammy.)
Short but big update on cab progress.
PSU has been installed, the missing exhaust fan has been sourced and installed, all the AC terminated and power tested, DC is good... The System 256 is installed along with the TD I/O to replace the old Namco I/O!
Boot it up! It's alive!
So no Conquest Mode... Well. This SHOULD be here before this Saturday, seriously hoping so! Got the DVD, Dongle and Conquest Data for super cheap. Only needed the Conquest memory card but this really worked out.
Running Version D of course,
Finally getting some more of the art kit from Serenative on the cab along with lots of Sanwa labels,
What's left is to wire up the control panel which won't take long, wire in the speakers then tune the monitor. Right now it's tuned for a very different application so it's going to look real real good. Also put the magnet back, I just noticed on the Conquest notice screen the green there. It's sitting on the shelf with the stereo.. Then it'll be fully playable!
After that, some more cleaning up of the front kick plate, need to get the rest of the missing bolts that hold the control panel closed and locks for the rear door. Tie up all the wiring inside.
It's coming along! Also fuck, looking back at this. This was a dope ass project.. And not even done lol
PSU has been installed, the missing exhaust fan has been sourced and installed, all the AC terminated and power tested, DC is good... The System 256 is installed along with the TD I/O to replace the old Namco I/O!
Boot it up! It's alive!
So no Conquest Mode... Well. This SHOULD be here before this Saturday, seriously hoping so! Got the DVD, Dongle and Conquest Data for super cheap. Only needed the Conquest memory card but this really worked out.
Running Version D of course,
Finally getting some more of the art kit from Serenative on the cab along with lots of Sanwa labels,
What's left is to wire up the control panel which won't take long, wire in the speakers then tune the monitor. Right now it's tuned for a very different application so it's going to look real real good. Also put the magnet back, I just noticed on the Conquest notice screen the green there. It's sitting on the shelf with the stereo.. Then it'll be fully playable!
After that, some more cleaning up of the front kick plate, need to get the rest of the missing bolts that hold the control panel closed and locks for the rear door. Tie up all the wiring inside.
It's coming along! Also fuck, looking back at this. This was a dope ass project.. And not even done lol
[ Heavens Third-Rate Tomboi 
NeSiCaXZXxxLiveCamz ]
NeSiCaXZXxxLiveCamz ]